EXEDY Racing Flywheels are made from solid one piece billet
chromoly steel forgings. They are specifically designed to reduce weight and inertia
for better engine response.

Most incorporate special design features to enhance air flow
to improve the cooling of the clutch. The ring gear teeth are milled onto the
flywheel unlike an aluminum flywheel where the ring gear is pressed onto the flywheel
and have the possibility of separating from the flywheel.

Features

Combination of low weight and high heat capacity

Designed for Rally, Drag and hi-performance Street

Reduced weight and inertia means snappier throttle response
and quicker shifting

Designed to increase airflow to help cooling (most)

One-piece flywheel -
starter teeth machined in place

Unlike an aluminum flywheel, ring gear can’t separate

Unlike an aluminum flywheel, friction surface can’t warp

May be resurfaced for future clutch service

Tested up to 18,000 rpm without failure

All EXEDY Chromoly Flywheels are SFI approved

8.8 LBS

Engine/Drivetrain Applications

All 90-01 B-series VTEC and non-VTEC engines

All 02-11 K20Ax engines

All 04-08 K24A2 (TSX)